Finished With Winter
Congratulations! You found a hidden egg!!! You have unlocked the special discount:
spend $15 get a finishing accessory for free
Your discount code is: FinishedWithWinter
L&L Kiln Parts
L&L Kiln Mfg. L&L Type-K 8 Gauge Thermocouple
Type-K 8 Gauge Thermocouple (Exposed) with Ceramic Terminal Block - Ceramic tube is 4" Long x 1/2" Diameter. This is the standard thermocouple used in the Easy-Fire, School-Master, Jupiter, DaVinci, Fuego, Doll/Test and Liberty-Belle kilns. It is normally supplied in the kiln with a thermocouple protection tube (although the protection tubes rarely need to be replaced. We strongly suggest that, when changing the thermocouple, you remove the protection tube and empty any metallic oxides that may have fallen off as the thermocouple aged. That material can touch the new thermocouple and make for uneven temperature readings inside the kiln.
$51.00
L&L Kiln Mfg. L&L Enclosed Power & Control Relay - 25 Amp - 12 Volt Coil
25 Amp Enclosed Power Relay with a 12 Volt Coil - Unit is the standard Power Relay used on All Polygonal and X2300-D & XB2300-D Series Kiln Automatic Control Panels, it is also used as the Control Relay for X2800-D & XB2800-D, X3200-D & XB3200-D, T2300-D & TB2300-D, and T3400-D & TB3400-D Series DaVinci Kilns and Hercules and Easy-Load kilns. This contactor is used interchangeably as a power contactor on both 240 volt and 208 volt kilns. The Enclosed Power Relay 25 Amp 12 Volt Coil is identical to the 240V Enclosed Power Relay. LOOK AT THE COIL VOLTAGE. L&L Kiln Mfg company uses both, and it is easy to get them confused. Always check the markings on the relay before ordering parts.
$50.00
L&L Kiln Mfg. L&L Easy Fire Kiln Element
Elements for L&L Easy Fire Kilns Not all elements are in stock and may be shipped direct from the manufacturer based on their current stock and lead times.
$70.00
L&L Kiln Mfg. L&L Peephole Plug
Ceramic Peep Hole Plug - Unit is a 1" Diameter x 5" Long Top Hat Style Plug (Stepped Head has a 2" Diameter and serves as a heat lock)
$15.25
L&L Kiln Mfg. L&L Infinite Switch - for 208v or 240v kilns
240 Volt Infinite Zone Switch - Unit includes a Mounting Nut. This can be used for both 240V and 208V Kilns. NOTE: Often a switch, when it burns out, exhibits overheating on the switch body at one of the spade electrical connection points. When this occurs, the mating connector on the wire may not give good electrical contact if refused. To reduce the possibility of overheating at this point on the new switch, we recommend replacing the female connector and the wire attached to it. If the switch body looks O.K. then do not replace the female wire connectors.
$55.00
L&L Kiln Mfg. L&L Thermocouple Protection Tube - New
Mullite Thermocouple Protection Tube - Unit is 5" Long x 1" Diameter with a stepped head for use with All Standard Length Type-K 8 Ga. Thermocouples. NOTE: This is the newer type open end tube which was put in service with new kilns starting in September 2020.Type-K 8 Gauge Thermocouple (Exposed) with Ceramic Terminal Block - Ceramic tube is 4" Long x 1/2" Diameter. The old, closed-ended protection tubes have been discontinued and are no longer available IMPORTANT NOTE: If you have the old closed-end tubes and you are changing one tube you need to change all of them to the new, open ended type. You MUST ALSO change the thermocouple offset to 0 for all zones. (see your kiln's manual for instructions on how to do this)
$46.00
L&L Kiln Mfg. L&L Type-K Thermocouple wire (by the foot)
Type-K Yellow Thermocouple Lead Wire. Rated to 105C, sold by the foot. NO tips are included with this wire
$6.70