Skutt Rolling Stand

Almost every kiln that Skutt sells comes with a stand but most of them are designed to stay put. Trying to move them with the kiln setting on them could result in a broken stand or even worse a broken kiln, or even worse, a broken you.

Often times you may want to move your kiln to clean under it or just get it out of the way when it is not being used. Think how nice it would be to get that car in the garage every once in a while.

Our rolling stands are constructed out of heavy duty, welded square tubing and fitted with high quality, locking steel castors ont models designed for large kilns. Steel castors will not develop flat spots if they sit too long in one spot unlike rubber or plastic wheels. They provide the recommended clearances from the kiln to the floor and many are adjustable in order to raise the loading level to a height that is comfortable for you.

This stand will position your kiln base 8" above the floor and is NOT adjustable.

 

Skutt Rolling Stand Adaptor

Have a Rolling Stand? Have an EnviroVent2? You may want to purchase the new EV2 Rolling Stand Adapter. The new adapter is a bracket that is designed to fit in between the cross supports of your Skutt Rolling Kiln Stand. The EnviroVent2 collection cup is spring loaded so it can move up and down with the bottom of the kiln as the brick expands and contracts. With the new bracket, the foot of the collection cup is spring loaded against the bracket instead of the floor. This way, when you roll your kiln, the cup goes with it. Now obviously you can't roll it very far because it it is attached with ducting to the motor, but it does allow you to move it for cleaning without having to reposition the cup.

 

Skutt Dual Intake Kit

The EnviroVent 2 has the capability of venting 2 large kilns (up to 12 cu/ft chambers) if you purchase the optional Dual Intake Kit. The kit is easy to install and comes with everything you need.

It includes the ducting Y, the additional ducting and the collection cup. It also necessary to purchase this kit if you are venting a kiln over 12 Cu/Ft like the KM1627-3 PK because of the need to extract more fumes.

 

Skutt Envirolink

The EnviroLink allows your controller to turn your EnviroVent 2 on or off based on how you program the kiln. Often times people will forget to turn on or off their vent. With the EnviroLink the controller does it for you. It is very easy to install. Simply plug your vent into the EnviroLink and connect the control wire from the EnviroLink into output 4 of your KilnMaster Controller. If you have a Kilnmaster kiln with a LinkBoard it is even easier, just plug the control wire into the socket on the side of the kiln.

 

Skutt KilnLink 

KilnLink is a cloud based Kiln Monitoring System that allows you to check the current status, view firing history, and see the diagnostic data of your kiln from anywhere you have access to the internet. It will even send you text messages if an event occurs such as, your kiln has cooled to a temperature where it is safe to unload or your kiln has been started.

KilnLink is extremely helpful when you have multiple kilns to manage with multiple people firing them such as school districts. Think of it as a kiln management system. From a single location you can check the health of every kiln in your district, monitor that kilns are being fired within school guidelines, and so much more.

With the new WIFI equipped Touchscreen Controllers there is also a free scaled down version of KilnLink that allows you to view just the current status of your kiln through a free APP.

Read more about KilnLink below:

https://skutt.com/kilnlink-page/