Overglaze Decal Application
All water slide overglaze decals are food safe and lead free. They should be applied after your ceramic piece has been glaze fired and work best over a white or light-colored glaze as they are semitransparent.
Materials Needed
• Overglaze Decal Sheet
• Glazed ceramic piece to apply decal to
• Bowl of warm water
• Plastic rib tool (I use the yellow Y3 mud tools rib) or a roller also works
• Sharp scissors
• Rubbing alcohol
• Lint free cloth
• Kiln ☺
1. Begin with using your lint free cloth and clean the area of the piece you are applying decals to with the rubbing alcohol to make sure all the oils from your skin and dust is off the surface.
2. Cut out the decal you want to use with scissors. We recommend cutting as close to the image as possible because the durable flux top coat will leave a slight line where you cut the decal out.
3. Place the decal in a bowl of warm water and wait about 30 seconds or until you are able to gently slide the decal from the paper backing.
4. Slide the decal off the paper backing onto your ceramic piece making sure you leave the decal face up.
5. Hold your decal in place and starting in the center use your rib or roller to press the decal onto the ceramic piece like you would a sticker on a car window. You want to be sure to start in the center and fan outwards to get all the bubbles out. Try to fan from the inside out over the edge so you don’t accidently pick up or rip the decal.
6. Carefully dry your decal with a new lint free cloth, again working from the center and working out. Allow the decal to dry overnight or at minimum until no moisture is left (about 6 hours).